- Community Home
- >
- Storage
- >
- Midrange and Enterprise Storage
- >
- HPE 3PAR StoreServ Storage
- >
- Port type will not change to "new" when configurin...
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-15-2016 09:50 AM
12-15-2016 09:50 AM
Port type will not change to "new" when configuring transport layer for RCFC
Good afternoon all,
I am working in a remote lab with two 3PAR's, a 7200 and a 8200 connected through a two 3000B, one for odd ports and one for even, for training purposes.
I am trying to configure the even onboard FC ports for RCFC through the CLI. When I issue the "controlport config rcfc <n:s:p>" command it accepts it but still says "free" under type when it should say "new". showport -par shows that the connmode is changed to rcfc. However, it does not come up as an rcfc port when calling showrctransport. When i try to initialize them i get an error that there are no rcfc devices on that port.
I have them zoned correctly, port 0:1:2 from 7k sees only 0:0:2 on 8k, and same for node 1 on each.
7k 3par OS 3.2.1 MU3
8k 3par OS 3.2.2 MU2
Your help is much appreciated, thank you.