HPE 3PAR StoreServ Storage

Simple "Full System Information Report"

 
SOLVED
Go to solution
Summerfest
Occasional Contributor

Simple "Full System Information Report"

Hello Everyone,

Is there a Simple "Full System Information Report" that would dump the following onformation about all of the hardware in my 3Par?

I'm really looking to a make a full report of all hardware models, firmware levels, drive models, serial numbers etc.

6 REPLIES 6
Sheldon Smith
HPE Pro

Re: Simple "Full System Information Report"

Go to the Service Processor, take a look at the CONFIG report it gathers daily. See if that's what you need....


Note: While I am an HPE Employee, all of my comments (whether noted or not), are my own and are not any official representation of the company

Accept or Kudo

Summerfest
Occasional Contributor

Re: Simple "Full System Information Report"

Thank you for your reply,

I do not see that iuunder the "Reports' section.

I have the following (All defaults by the way), and I cannot fins a report that shows and specific details, nor the one you name.

 

Name
CPG Space
CPU Compare by Performance
Exported Volumes Compare by Performance
Host Port Compare by Performance
Physical Drive Compare by Performance
Real Time Exported Volumes Performance
Real Time Physical Drive Usage Total IOPs
System Capacity
VV Space

Sheldon Smith
HPE Pro

Re: Simple "Full System Information Report"

Those look like SSMC reports.

You need to log on to your Service Processor.


Note: While I am an HPE Employee, all of my comments (whether noted or not), are my own and are not any official representation of the company

Accept or Kudo

Summerfest
Occasional Contributor

Re: Simple "Full System Information Report"

I do not see any report section on the Service Processor.

Unless I'm missing something...

Cali
Honored Contributor
Solution

Re: Simple "Full System Information Report"

Hi Summerfest,

I have explained it in my blog post here:

https://d8tadude.com/2018/02/07/creating-a-3par-document-bundle/

Cali


======================
I'm not an HPE employee, so I can be wrong.
sbhat09
HPE Pro

Re: Simple "Full System Information Report"

Hello @Summerfest,

The command outputs of 'showversion -a -b' and 'showsys -d' would help you on what you are looking for.

Regards,
Srinivas Bhat

If you feel this was helpful please click the KUDOS! thumb below!
Note: All of my comments are my own and are not any official representation of HPE.


I am an HPE Employee

Accept or Kudo