host without ID and Persona

[francisco82]

hi Team, i have a question... i removed one host and i removed all zone of this host on the SW SAN, but i still seeing the host in the 3par:

Id Name WWNs Ports Nodes
-- test1 2 4 0,1,2,3
-- test2 2 4 0,1,2,3
--  Test3 4 0,1,2,3

how i can remove in totally the host?

Regards...

[sbhat09]

Hi @francisco82,

In the actual 'showhost' output does it show the full WWN as well?

Have you tried the command 'removehost <hostname>' ?

Regards,
Srinivas Bhat

If you feel this was helpful please click the KUDOS! thumb below!
Note: All of my comments are my own and are not any official representation of HPE

[francisco82]

hi @sbhat09,, thank for answer me,

if i run the showhost command.. i can see th WWW of the HBAs but i need add one "*" in the beginning of the host name:

TEST01 cli% showhost *test
Id Name Persona -WWN/iSCSI_Name- Port
-- test --- 1000AA31B50000AB 3:1:1
1000BB31B50000B9 0:1:2
1000BB31B50000B9 2:1:2
1000AA31B50000AB 1:1:1

[Cali]

Try this:

servicehost remove

Cali

[francisco82]

hi @Cali , yes this is the first command that i  ran...

[sbhat09]

Hi @francisco82,

With reference to 3PAR CLI guide - https://support.hpe.com/hpesc/public/docDisplay?docId=c04204279

I think here the hosts with multiple specifiers are deleted with single specifier. So, the residual specifiers are still showing up.

As per pg270, please try to delete the hosts again with 'removehost <hostname>' (This commands deletes hosts including all specifiers). If the residuals are still remaining, try to remove them with the relevant options and specifiers like:

removehost [options] <specifiers>

Ex:
removehost -port n:s:p
removehost -iscsi iscsi_name

Regards,
Srinivas Bhat

If you feel this was helpful please click the KUDOS! thumb below!
Note: All of my comments are my own and are not any official representation of HPE