HPE 9000 and HPE e3000 Servers
1748080 Members
5036 Online
108758 Solutions
New Discussion юеВ

Re: A5191B not working with 550MHz procs

 
Dane Van Steenwyk
Frequent Advisor

Re: A5191B not working with 550MHz procs

I have everything installed in the correct order and have both psm's in. Firmware to 44.28.

Definitly not a problem with the other hardware or order. I have been troubleshooting this for days now. The problem is the board or the procs I was just hoping someone from HP might know how to solve this problem or tell us what we can do about it.

I've tried a dozen different procs and half a dozen psm's all my memory is good. It is definitely the procs or the upgrade is not complete. Also, this is happening on three different L2000's.
Dane Van Steenwyk
Frequent Advisor

Re: A5191B not working with 550MHz procs

Another thing I tried is putting two 440's and two 550's in and dip switches to 440 settings. Just to make sure it worked with four procs(don't have 4- 440's). I noticed then that the HVERSION changed on the 550's that were 0x05d9 are now 0x05c4. The cversion 3.1 procs on this attachment are the same ones used in the L2000 in my attachment earlier. Just something else to think about. Maybe it sounds like the boards in our L2000's are bad.
Ted Buis
Honored Contributor

Re: A5191B not working with 550MHz procs

Did all four boot at 440MHz okay?
Mom 6
Dane Van Steenwyk
Frequent Advisor

Re: A5191B not working with 550MHz procs

Yes all four booted up fine. I put my information results in the attachment provided. Thanks for your help.
Ted Buis
Honored Contributor

Re: A5191B not working with 550MHz procs

So you set the switches for 440MHz on the 550MHz processors. Is there possibly a setting for 540MHz versus the 550MHz? I haven't seen anything on this, but I don't have a service manual, and I don't see on at www.docs.hp.com.
Mom 6
Ted Buis
Honored Contributor

Re: A5191B not working with 550MHz procs

"If installing a second CPU, on rp5400 or rp5450(a.k.a. L2000), remove the processor terminator in slot 3."
Mom 6