Adding GSP user

[mvr]

Hello,

I have forgot login for one of mine GSP's, so I reseted by using

stty +resetGSP < /dev/GSPdiag1

I can login ( using ctrl+b ) with no problem.
For the security reasons, I would like to set up a user name and password.
When I type "CU", I get prompt to change the wide parameters ( which I click on "n" ). The next one "Do you want to modify the user number 1 parameters? (Y/[N]/Q to quit)", I click on "y". When I'm prompt for new user name, I type "root" and press enter. Screen scrolls up and it skips the lines where I should confirm changes with (Y/N). System goes back to the same prompt asking for a user name. I tried to use users root, Admin and mvr with no luck.
I am stuck at this screen.

[Torsten.]

Sounds to me like a problem with console emulation program. What are you using?

[mvr]

I am at the console, directlly connected to the GSP. Not sure what is emulator ( if any ) set to.

[Torsten.]

For example, if you are using a laptop (even with serial cable) you use a program, let's say putty in an emulation mode, e.g. vt100, xterm or whatever.

Even hardware consoles have several modes, e.g. hpterm, vt100, vt220 ...

[mvr]

Ok, how do I check that on the console?

[Torsten.]

What console do you have?