HPE Community
HPE 9000 and HPE e3000 Servers
1752644 Members
5707 Online
108788 Solutions
New Discussion

Re: Bus adapter failure

 
Llewellyn le Hane'
New Member

‎10-23-2003 05:05 AM

‎10-23-2003 05:05 AM

Bus adapter failure

I'm working on a L3000 that had a failed bus adapter 0/8. I replaced the IO backplane and the same bus was still DEAD!!
The PDC does not pick it up. It also give me an unexpected configuration change error.

Any advice??
0 Kudos
1 REPLY 1
Stefan Stechemesser
Honored Contributor

‎10-24-2003 01:51 AM

‎10-24-2003 01:51 AM

Re: Bus adapter failure

sounds like you should call an HP engineer to get some professional help. Possible causes of a bus adapterfailure: 1.) Bad PCI backplane (good try to replace it) 2.) Bad PCI card 3.) Bad system card.

Best regards

Stefan
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.