Cannot save IP MP Config on rp3440

[toni osta]

Hi ,
I have a rp3440 server ,
i want to give an IP to the management card ,
i have loged from console using a serial cable , i have chosse CM than LC , i have disabled the DHCP , he asked me to confirm ,then to reset by XD -R , at this level the DHCP is disabled ,
when i put LC , again , and choose I , S and G for ip and subnet and Gateway , i put my valuses , but it did not give me the opyion to save them , so if i Quit , it looses changes and LC give me the old values again ,
+ : inconsistent parameters is shown next to the IP , Subnet and gateway ,
so how i can save the IP config for MP ,

Thank you

[Steven E. Protter]

Shalom,

You may need to open a hardware call. Bad hardware could prevent storage.

You could also be trying an illegal network configuration that is not consistent.

Perhaps post the ip/netmask information and someone can help you find the flaw.

SEP

[Robert-Jan Goossens]

Hi,

Could you post your current configuration? with the LS command?

To disable DHCP, use the LC command.

1.
From the LC command menu, enter D and press Enter.

2.
Follow the instructions on the screen to change the DHCP status from Enabled to Disabled.

3.
Enter XD -R to reset the iLO MP.


Use the LC command to enter information for the IP address, host, subnet mask, gateway parameters, and so on.

Enter XD -R to reset the iLO MP.

After the iLO MP resets, log in to the iLO MP again and enter CM at the MP:> prompt.

To confirm that DHCP is disabled and display a list of updated LAN configuration settings, enter LS.

Regards,
Robert-Jan

[Torsten.]

After modify, you get this line and question:

-> Check all LAN parameters to ensure they are correct before commit.
-> All LAN and Web connections will be dropped if you confirm the changes.

Enter Parameter(s) to revise, Y to confirm, or [Q] to Quit:



There is no option so save, but you need to confirm the changes.


Press "y"!

[cnb]

Hi Toni,

Can you post a screen capture?

Have you tried disconnecting the network cables and try it again?
-or-
Maybe try setiing it using the ARP methods listed in Chapter 3?

http://bizsupport2.austin.hp.com/bc/docs/support/SupportManual/c01404120/c01404120.pdf

Since it is giving inconsistent parameter messages have you verified your terminal settings to make sure no hidden/escape sequence characters are being entered by mistake?


HTH,