Change the initiator scsi id for sc10

[Jason Martens]

Hey all, I know this is probably out there somewhere, but I was having a hard time finding it.

I have an rp5470 with 1 dual channel scsi card (SCSI C896 Ultra2 Wide LVD, according to ioscan). I also have an SC10 in full bus mode. I would like to change the scsi id of the second initiator so I can have multiple paths to the SC10. How can I do that?

Jason

[Sundar_7 · Accepted solution]

Hi Jason,

this is how you can do it.

1) Reboot the system
2) Interrupt the autoboot
3) BCH> Configuration

Enter in to the configuration menu

4) Configuration Menu> SCSI INIT

5) Reboot once again.

-- Sundar

[Jason Martens]

Thanks for the help. That worked great. The only thing was I had to go into the SERvice menu first to use the SCSI INIT command.