Error message on bootup

[Paul Bertino]

BOOT_NO_BOOT_SELECTION. Does anyone know what this means?

[mirco_1]

hi,

it is a Chassis logs message.
It is a System Firmware Reporting.

I can see you that the sense is literal :

Look : BOOT
sense : NO_BOOT_SELECTION

DM.

[Sยภเl Kย๓คг]

Hi,

What is the model of the machine.

This is a system firmware detected error when it tried to boot through the boot path set in the stable storage and was not found. Check the pri and alt boot path set, and give a sea command in pdc to find the available bootable devices.Then compare it with the pri and alt boot set, correct if required. If any hardware failure replace the disk.
Regards,
Sunil

[Scot Bean]

Could simply mean that no software is installed, or no hard drives present.