FLT A088:FLT 11BF

[Fadia Almarei]

Dear All
i have HP9000 K460 server running HP-UX 11.0 i have the following errors on the console
FLT A088
FLT 11BF
i see some answers tell that it is an I/O error or due to console,i try to change the console itself but i have the same failt, so kindly advice in what should i do.
BR,
Fadia

[Florian Heigl (new acc)]

I'll have this moved to the servers forum, I hope the people there can help You better on diagnosing the error codes.

I can only tell You to call a HP tech :(

[melvyn burnard]

You appear to have a problem with hte console path. If you have changed the physical console, it is time to log a call, as I suspect you have a problem with the core i/o card, or the backplane.

[Fadia Almarei]

so how to solve this

[Torsten.]

Hi Fadia,

please interrupt the boot process and check the hardware path to your console (this should be something like 10/4/0.0).

You will get a display like this:

------------------------------------------------------------------------------
(c) Copyright 1990-1998, Hewlett-Packard Company, All rights reserved
------------------------------------------------------------------------------

Processor Speed State CoProcessor State Cache Size
--------- -------- --------------------- ----------------- ----------

0 120 MHz Active Functional 256 KB
1 120 MHz Idle Functional 256 KB
2 120 MHz Idle Functional 256 KB
3 120 MHz Idle Functional 256 KB

Central Bus Speed (in MHz) : 120
Available Memory (bytes) : 2281701376
Good Memory Required (bytes): 54038528


Primary boot path: 10/0.6 (dec)
Alternate boot path: 10/0.4 (dec)
Console path: 10/4/0.0 (dec)

IMPORTANT ^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^

Keyboard path: 10/12/7.0 (dec)

HTH

[Alessandro Pilati]

Fadia, the following errors:

FLT A088 = No Console Found, Unable to Boot
FLT 11BF = Slave CPU 1 halted due to catastrophic boot failure

Correspond respectively to a fault coreI/O (impossible to boot) and a consequently fault of slave CPU1.

Have you a modem attached? Try to disconnect the modem.

Check if the remote mode of console is turned on (see asterisk in this field).
Then try resetting the console :
power it off,
press and hold 'd' key,
power console on,
wait for beep

Anyway, check at this posted forum:
http://forums1.itrc.hp.com/service/forums/questionanswer.do?threadId=129008

If you don't get resolution, contact HP.

Regards,
Alex