HPE 9000 and HPE e3000 Servers
cancel
Showing results for 
Search instead for 
Did you mean: 

GSP Error on L2000

 
Victor_5
Trusted Contributor

GSP Error on L2000

Installing 11i on L2000, cold install, trying to boot from CD.

Go to PDC, "sea" and found cd-rom is "P4", issue "bo p4", got the following error:
IPL error: bad LIF magic

System name: xxx
Alert level: 6=boot possible, pending failure - action required

Reason for alert:
Source: 8=i/o
Source detail: 6=disk Source id:0
Problem details: 0=no problem detail
...

Any idea? Urgent!
4 REPLIES 4
RAC_1
Honored Contributor

Re: GSP Error on L2000

May be bad CD. Check cd drive, CD and try again.
There is no substitute to HARDWORK
Jeff Schussele
Honored Contributor

Re: GSP Error on L2000

Hi Victor,

If you're sure that the P4 drive was the CD/DVD, then the 2 possible causes are:

1) Bad disk
2) Bad drive

If the CD is successfully read in another drive, then check SCSI cabling, termination & proper ID.

Rgds,
Jeff
PERSEVERANCE -- Remember, whatever does not kill you only makes you stronger!
PVR
Valued Contributor

Re: GSP Error on L2000

I faced the same problem recently.

That was a disk problem.
Don't give up. Try till success...
DGH_2
Valued Contributor

Re: GSP Error on L2000

Hi,
it's a disk problem.
try to remove the disk and install it again.

DGH