GSP Firmware needed for rp5450

[Abdul Salam H S_1]

Hi,
We are facing a strange problem in our rp5450 server.We are able to see only one serial port, when we go to Add a terminal through SAM. Actually, we need to verify that the remote modem port is working for configuring a modem.
The output of "ioscan -fn" is like:

tty 1 0/0/4/1 func0 CLAIMED interface PCI Serial (103c1048)
/dev/GSP/diag2 /dev/cul0p2 /dev/diag/mux0
/dev/mux0 /dev/ttyd0p2

This means the other serial ports on the GSP are missing. How do I enable those ports? Is there any GSP or PDC firmware upgrade needed to solve this issue. Our GSP firmware version is :
Hardware rev N0 Firmware rev B.02.17

With Best Regards,
Abdul Salam

[Shaikh Imran · Accepted solution]

Hi,Salaam..

Try this doc may help you sir.

Regards,

[Robert-Jan Goossens]

Hi Abdul,

Check this doc from the ITRC database.

Document description: Unable to configure modem on the remote console port of an rp5470
Document id: USAMKBRC00013483

http://www4.itrc.hp.com/service/cki/docDisplay.do?docLocale=en_US&docId=200000070866459

Regards,
Robert-Jan

[Abdul Salam H S_1]

Hi Imran & Robert,

Thanks for the wonderful documents.There are lots of info which most of the people are not aware of.
Imran, where did u get this doc? And where are you now?
I'll try these things and give feedback.

Thanks & Best Regards,
Abdul Salam

[Shaikh Imran]

Hi,Abdul

I made this document just when you asked for.


sorry itrc folks some personal.
Abdul i am here
imran@hathway.net
or
s_imran_r@yahoo.com

P.S.
No points here please.

Regards,
Imran Shaikh