HPE 9000 and HPE e3000 Servers
cancel
Showing results for 
Search instead for 
Did you mean: 

GSP Flow Control

 
Peter84
Advisor

GSP Flow Control

I have an error message on gsp:

Guardian Service Processor WARNING: GSP is permanently flow controlled very likely by
the local serial port. You need to remove the flow control condition.


How I can resolve this problem?
5 REPLIES 5
Torsten.
Acclaimed Contributor

Re: GSP Flow Control

Do you have a modem connected?


Check the serial port settings with

GSP> ca

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
Peter84
Advisor

Re: GSP Flow Control

GSP> ca


CA

This command allows you to modify the local and remote modem serial port
configurations. Current configuration settings:

Local Console Serial Port bit rate: 9600 bits/s
Local Console Serial Port Flow Control:
Torsten.
Acclaimed Contributor

Re: GSP Flow Control

No more output?

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
Peter84
Advisor

Re: GSP Flow Control

CA

This command allows you to modify the local and remote modem serial port
configurations. Current configuration settings:

Local Console Serial Port bit rate: 9600 bits/s
Local Console Serial Port Flow Control:


Guardian Service Processor WARNING: GSP is permanently flow controlled very likely by
the local serial port. You need to remove the flow control condition.

Hardware
Local Console Serial Port Terminal Type: vt100
Remote Console Serial Port Modem Protocol: CCITT
Remote Console Serial Port Modem bit rate: 19200 bits/s
Remote Console Serial Port Modem Flow Control: Software
Remote Console Serial Port Modem Transmit Configuration Strings: Enabled
Remote Console Serial Port Modem Presence:

Guardian Service Processor WARNING: GSP is permanently flow controlled very likely by
the local serial port. You need to remove the flow control condition.

always connected

Do you want to modify the Local Console Serial Port settings? (Y/[N])

Do you want to modify the Remote Console Serial Port Modem settings? (Y/[N]) y
y

Current Remote Console Serial Port Modem Protocol: CCITT
Do you want to modify it? (Y/[N]) y
y
Enter Modem Protocol (Bell / CCITT):

Sorry, wrong input...

Current Remote Console Serial Port


Guardian Service Processor WARNING: GSP is permanently flow controlled very likely by
the local serial port. You need to remove the flow control condition.

Modem Protocol: CCITT
Do you want to modify it? (Y/[N])

Current Modem bit rate: 19200 bits/s
Do you want to modify it? (Y/[N])


Current Flow Control: Software



I must set HARDWARE?
Torsten.
Acclaimed Contributor

Re: GSP Flow Control

I guess it should be "software" for both, see

http://www.docs.hp.com/en/A5191-96018/ch04s03.html

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!