GSP setting

[Sunil Sharma_1]

How can i check GSP setting without getting Console access?
Is there any way ?


Sunil

[Hoefnix]

Hi,

I only know of a way to reset the GSP from the OS.
stty +resetGSP
But I've never seen a way how to configure it from the commandline(OS).
The above info will not be new for you I think.

Regards,
Peter

[G. Vrijhoeven]

HI Sunil,

If you connect ot a GSP you do not automaticly have console access, if you retured to the GSP last time ( ? ) and did an exit. If you access GSP you need to type to connect to the console. Settings of the GSP can be checked. use the or to get a command list.

HTH,

Gideon

[Hoefnix]

Did you see next thread?
http://forums1.itrc.hp.com/service/forums/questionanswer.do?threadId=181175

When reading the thread that it is linked to, It might be possible if its not a very-new GSP

They use the cu -l

HTH,
Peter

[Karthik S S]

On a lighter note, if you are using a SUN box try eeprom :-))

-Karthik S S

[Jeff Schussele]

Hi Sunil,

Nope - sorry.
There's no way to "interrogate" the GSP w/o console access. It's a whole "other" computer in and of itself & HP-UX has no way to access it's OS. Only via console (LAN or serial) can you "talk" to the GSP.

Rgds,
Jeff

[Joshua Scott]

Not possible, this is a security feature. anyone who could get GSP access would have complete control over the system, thus it would be potentially dangerous to allow someone to be able to get to it without console access.

Josh