HP 700/60 console problem.

[ankurp]

Hi friends,

Need ur help to get into old HP 9000 D class server thr. console.
We are connected to the server thr. console but we cannot see what we r typing on the screen, also pressing the 'm' and 'd' keys key brings it to the next prompt. The server is not on network. How can we set the console to access this server. In terminal config , TermMode is HP.
pls. help

rgds
Ankur

[Torsten.]

First reset the console.
Switch power off (terminal, not the server!), press the "d" key and hold while switching on for some seconds. Release the key. The terminal is now on default settings (HP term, US keyboard) and should work.

[Andrew Rutter]

hi,

did you get this terminal working?

If not check that the terminal has remote mode enabled

select modes from boxes across the bottom of screen and select remote mode(put * in box)

then press return and the signal/prompt should be there

Andy

[ankurp]

Nop, no luck yet.
Remote mode is set. And also default settings are set.
We cant input character "m" , when we enter "m" it goes to new line. We cant make out how to get in that server.
Pls. help.

rgds
Ankur