HPE Community
HPE 9000 and HPE e3000 Servers
1753819 Members
8994 Online
108805 Solutions
New Discussion

Hardware device with 2 paths

 
Betty Hardin
Frequent Advisor

‎12-10-2006 07:52 AM

‎12-10-2006 07:52 AM

Hardware device with 2 paths

Rebooted our production server this morning; it hung. Got it up again with a hard boot - but now see a disk in sam that shows two hardware paths. When I attempt to "view more information" for that device, I get a memory fault (coredump) message.

How can I correct this?

While I am on the subject of issues - Veritas Entrprise Manager also caused a coredump. We don't use it - I'd like to remove it. How can I do that?
0 Kudos
1 REPLY 1
Torsten.
Acclaimed Contributor

‎12-10-2006 07:59 PM

‎12-10-2006 07:59 PM

Re: Hardware device with 2 paths

Hi,

some more details are needed.
What kind of hardware device, what kind of connection (SCSI/FC)?
You should post an "ioscan -fn" for the beginning.

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.