HPE 9000 and HPE e3000 Servers
cancel
Showing results for 
Search instead for 
Did you mean: 

Help me, RP2450 has no any display

 
SOLVED
Go to solution
SUNAUS
Occasional Advisor

Help me, RP2450 has no any display

I have a RP2450 server, when I turn on, the light is: power is on, other are off, and on Console has no any display.

there is a web console card in this server, I can connect web console by LAN, there is no any display on web console either.

Only Power light is on, how should I do? Could you help me? thanks a lot!
5 REPLIES 5
Andrew Young_2
Honored Contributor

Re: Help me, RP2450 has no any display

Hi

When you say powering on, are you pushing the power button or merely adding power to the server?

Regards

Andrew Y
Si hoc legere scis, nimis eruditionis habes
Stefan Stechemesser
Honored Contributor
Solution

Re: Help me, RP2450 has no any display

Hi,

If really the Front Panel LED state is that the Power LED is solid on and alls others (RUN, ATTENTION, FAULT) are off, this means that the system cannot execute the PDC (bios). This could be a hint on a general system failure like bad CPU or Systemboard.
But you should be able to get output from the GSP by pressing CTRL-B on the console. if this does not work, then the GSP card may be bad or the console is not properly connected
(see http://docs.hp.com/en/2411/rp24xx_customer.pdf )
I would ask the next HP Support Center for help.

best regards

Stefan
Asif Sharif
Honored Contributor

Re: Help me, RP2450 has no any display

SUNAUS
Occasional Advisor

Re: Help me, RP2450 has no any display

I test it again. it is faulty GSP. I replace a good GSP board, RP2450 is well.
Thanks.
SUNAUS
Occasional Advisor

Re: Help me, RP2450 has no any display

faulty GSP