HPE 9000 and HPE e3000 Servers
cancel
Showing results for 
Search instead for 
Did you mean: 

How can I configure a Management Card in a rp3440-4

 
SOLVED
Go to solution
Carme Torca
Super Advisor

How can I configure a Management Card in a rp3440-4

Hi,

I would like to configure a Management Card in a rp3440-4. Does anyone knows how can I do this?

Thanks a lot of!
Carmen.
Users are not too bad ;-)
6 REPLIES 6
Victor Fridyev
Honored Contributor
Solution

Re: How can I configure a Management Card in a rp3440-4

Hi,

If you mean lan console, so you have to connect with either HP dumb terminal to the console port or with a PC using hyperterm, reflection or procomm, connecting com port to the console port of rp.
Pressing ctrl-B you you get MP prompt
The default user/password is Admin/Admin (case sensitive)
Choose from the menu cm and from the next menu lc. Answer on the question and connect management port rj45 to the network.

HTH
Entities are not to be multiplied beyond necessity - RTFM
Luk Vandenbussche
Honored Contributor

Re: How can I configure a Management Card in a rp3440-4

You have a label at the front, next to your disks. Here you find the mac adress.

You can give it an ip adress with arp

You can change these settings afterwards with

telnet ip
login
CM
LC
Torsten.
Acclaimed Contributor

Re: How can I configure a Management Card in a rp3440-4

The MP is using DHCP by default nowadays. Have a look into your system documentation for the name, something like mp08xxxxxxxx.

You can telnet to this name , login with Admin/Admin and configure the MP.

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
Torsten.
Acclaimed Contributor

Re: How can I configure a Management Card in a rp3440-4

The MP is using DHCP by default nowadays.

The name is mp+MAC_address, e.g.

mp00123456789a

Connect with telnet using this name, logon with Admin/Admin and configure.

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
Sivakumar TS
Honored Contributor

Re: How can I configure a Management Card in a rp3440-4


Hi,

If it is a new card, you may have to connect to the serial port first,

using 9600-8-N-1 settings and

configure IP address and other network config for the MP, using MP>CM>LC

Regards,

Siva
Nothing is Impossible !
mits
Respected Contributor

Re: How can I configure a Management Card in a rp3440-4

I suggest you will refer the operation guide available on the web below. See, page 32.

http://docs.hp.com/en/A7137-96003/A7137-96003.pdf

OR
http://docs.hp.com/
-> Hardware
-> Enterprise Servers, Workstations
Systems Hardware
-> HP 9000 rp3410/rp3440 Server
-> HP 9000 rp3410/rp3440
Operations Guide