- Community Home
- >
- Servers and Operating Systems
- >
- Legacy
- >
- HPE 9000 and HPE e3000 Servers
- >
- INIT C440 AP Console error when booting D220 serve...
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-17-1999 12:49 PM - last edited on 01-29-2012 10:09 PM by Ajay-Kumar
12-17-1999 12:49 PM - last edited on 01-29-2012 10:09 PM by Ajay-Kumar
INIT C440 AP Console error when booting D220 server
when I boot my HP9000 D220 server it does not come up successfully it fails
during the hardware diagnostic phase.. with an error on the status display of
'INIT C440 AP CONSOLE'
I have got around this problem before by pressing a ctrl + a key but I don't
know what key..
Anyone hit this before and knows what key to press during boot up?
Thanks
-------------------------------
P.S. This Thread has been moved from Servers --> General to Servers --> HP 9000 - Forum Moderator
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-19-1999 08:50 AM
12-19-1999 08:50 AM
Re: INIT C440 AP Console error when booting D220 server
posting it here just incase someone else may need it...
You might try reseting the console. If it is a 700 series console than hold
down the D key while power cycling the console. You should hold the d key down
for about 10 seconds after turning the power back on.
After 10 seconds, hit the enter key and you should get a message saying default
configuration used. Hit enter a couple of times and see if you
error message goes away.