HPE 9000 and HPE e3000 Servers
cancel
Showing results for 
Search instead for 
Did you mean: 

K 260 booting problem

 
Vinod_22
Advisor

K 260 booting problem

Hi
I have K 260 in which after installation of patches when I restrted the system the display shows INIT C440 and nothing is coming on my console vt100 terminal.

Where is going wrong?

Thanks

Vinod
3 REPLIES 3
Cheryl Griffin
Honored Contributor

Re: K 260 booting problem

Reset your console: turn it off, hold down the D key and power it back on. This resets the defaults.

INIT C440 means your console is the problem.
"Downtime is a Crime."
Jeff Schussele
Honored Contributor

Re: K 260 booting problem

I agree with Cheryl - your console is the problem. But I see you're running an old DEC VT100. Are the communication parameters correct?
9600 baud - 8 data bits - 1 stop bit - No parity & X/on X/off flow control.

HTH,
Jeff
PERSEVERANCE -- Remember, whatever does not kill you only makes you stronger!
barrett cooper
Occasional Advisor

Re: K 260 booting problem

The issue is that the key on the front of the server is in the service position. Switch it to the run position. When it is in the service position and a ctrl-B has been entered you will be in a service menu. You can also enter "co" at the console to leave te service menu.