HPE 9000 and HPE e3000 Servers
cancel
Showing results for 
Search instead for 
Did you mean: 

L2000 Error code

 
SOLVED
Go to solution
Larry Manus
Occasional Contributor

L2000 Error code

We had a 1 our our HPUX L2000 shipped from one of our call center to our data center on COS. Once it arrived ---it freezes during the POST --- via the console, it displays the processor - memorry I/O - more memory infor then freezes at:
I/O config 8204
I've removed all the disks and Quad Nic's so far -- still same.
tks for any harware code info
3 REPLIES 3
Adisuria Wangsadinata_1
Honored Contributor
Solution

Re: L2000 Error code

Hi there,

You can see the document at this url below about 'User Guide - rp5400 Family of Servers' :

http://www.docs.hp.com/hpux/onlinedocs/A5191-96018/A5191-96018.html

See chapter 6 - Troubleshooting.

Hope this information can help you.

Best Regards,
AW
now working, next not working ... that's unix
Larry Manus
Occasional Contributor

Re: L2000 Error code

Adisuria -- thsk very much for the responce --- It's the first time we've seen this doc yet - tks again. I'm reviewing it right now.
As a side note:
- Via console access - after the freeze at "I/O ~~~ config ~~~~ 8204" -- I nevet get get the BCH "Boot Console Handler"
I can get in to the GSP ---
* Error log only indicated last time I disconnected the power
* Last boot doesn't seem to indicate but the last successfull boot (back on 5/13/2003)
Lights: Run Flashing Pwr ON (other off)

I'll keep digging through the doc to see if there is any help on this 8204 code
tks again
lm
Scot Bean
Honored Contributor

Re: L2000 Error code

Appears that the 8204 code is a routine one that appears on every good boot. It indicates only that IO Config has started.

Important to know what version of firmware (PDC) is on the server.