cancel
Showing results for 
Search instead for 
Did you mean: 

L2000

 
patrick_132
Advisor

L2000

trying to set up 2 L2000's with 4 440 mhz procs.

when all 4 cpu's are installed the system powers on but will not go in to the testing mode.

With 1 cpu and term the system's run fine, with 2 cpu's they run fine, with 3 cpu's they run fine.

I've swaped the cpu's around to make sure they are all good as well as the pdu's.

side note with all 4 cpu's installed the ss command shows cpu 0,1,3 installed and configured. cpu 2 not installed. the dip switches are set at on off off off on, and i've tried on off off on on.
4 REPLIES 4
Robert-Jan Goossens
Honored Contributor

Re: L2000

Hi Patrick,

Did you install processor support modules ?

http://www.docs.hp.com/hpux/onlinedocs/A5191-96022/A5191-96022.html

Regards,
Robert-Jan
patrick_132
Advisor

Re: L2000

Yes there is 2 processor support modules in each of the L2000's.
Robert-Jan Goossens
Honored Contributor

Re: L2000

Try to first install one extra cpu (3) order mentioned in the doc I gave, then reboot and add the number four.

HTH,
Robert-Jan
patrick_132
Advisor

Re: L2000

Thanks that worked on one of the units its now up on 4 cpu's with 11I loaded, the other is now giveing the following error with 4 cpu's installed, stm was run with 3 cpu's and the 4th is a known good cpu.

System Name = Uninitialized
Alert Level 7 = Reserved
Source: 0 = Unknown, No Source Stated
Source ID: FF