HPE 9000 and HPE e3000 Servers
cancel
Showing results for 
Search instead for 
Did you mean: 

LED red rp3410 over temp

 
LEO SIMON_1
Advisor

LED red rp3410 over temp

Hi

I had one rp3410 with LED front panel red because of over temperature.
I can't turn off the LED after reading the log from MP.
Is there any other way to turn off the led power off without shutdown and disconnect the power supply ?
I also test to reset MP using XD - R without result

Thanks

Leo
4 REPLIES 4
Torsten.
Acclaimed Contributor

Re: LED red rp3410 over temp

Hi,

perhaps there is another reason for the light like a full BMC log.
Review the logs again and clear the logs if needed.
I would also check if a new firmware is available for your system.

see
http://h20000.www2.hp.com/bizsupport/TechSupport/SoftwareDescription.jsp?lang=en&cc=us&prodTypeId=15351&prodSeriesId=2512012&prodNameId=406773&swEnvOID=54&swLang=13&mode=2&taskId=135&swItem=pf-45260-1

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
LEO SIMON_1
Advisor

Re: LED red rp3410 over temp

Hi Torsten,

I had already clean all the log and the firmware also the newest.

But the LED still red

LEO SIMON_1
Advisor

Re: LED red rp3410 over temp

I just found we can reset BMC using MP command RB to turn off the LED
But on the newest FW this rb is not allowed to power down LED

LEO SIMON_1
Advisor

Re: LED red rp3410 over temp

Case closed