HPE 9000 and HPE e3000 Servers
cancel
Showing results for 
Search instead for 
Did you mean: 

Led system red on my hpux server

 
kacou
Regular Advisor

Led system red on my hpux server

I have a problem of cooling on my server.

# uname -r
B.11.23
# model
9000/800/rp7420
#
The temperature returned to the normal but the system led is still red.

8 REPLIES 8
George_Dodds
Honored Contributor

Re: Led system red on my hpux server

Check your gsp logs for errors

http://docs.hp.com/en/A5201-90017/ch02s06.html

Cheers

George
Deepak Kr
Respected Contributor

Re: Led system red on my hpux server

Hi,

Take a session for GSP and see logs.

Clear logs and see the status again.

Regds,
Deepak
"There is always some scope for improvement"
Highlighted
Anshumali
Esteemed Contributor

Re: Led system red on my hpux server

I hope logs need not be clear to off the LED. You can just traverse to the end of the logs and....its off. Though you should really be careful that issue is closed.
Dreams are not which you see while sleeping, Dreams are which doesnt allow you to sleep while you are chasing for them!!
Kenan Erdey
Honored Contributor

Re: Led system red on my hpux server

Hi,

in some cases red led does not disappear. You can try power down and plug the power cable off. after some minutes power up again.
Computers have lots of memory but no imagination
Jeeshan
Honored Contributor

Re: Led system red on my hpux server

go to MP console and there, see the system event logs.

sometimes it seen that, if your temperature comes to its normal stage the LED indicator became normal. If its not then you need to reboot the system.

but before than you can log a case to HP and reconfirm to whether reboot or anything else steps you need to take.
a warrior never quits
Asif Sharif
Honored Contributor

Re: Led system red on my hpux server

Hi kacou,

If you have seen the logs and still LED is red then Reboot will solve your problem.

Regards,
Asif Sharif
Regards,
Asif Sharif
Akif_1
Super Advisor

Re: Led system red on my hpux server

Hi,

Connect via serial port / MP port see the system event logs and other logs as well to know the actual problem.


Good luck ....... dont forget to assign points.
T(ogether) E(very one) A(chive) M(ore)
Ron Irving
Trusted Contributor

Re: Led system red on my hpux server

According to the screenshot you attached, you have a cooling problem. The thing to do would be to log into the MP, and type cm. At the MP>CM prompt, type ps, and choose cabinet. That should tell you if any fans have failed, and their location.

Hope this helps.

ron
Should have been an astronaut.