HPE 9000 and HPE e3000 Servers
cancel
Showing results for 
Search instead for 
Did you mean: 

MP Firmware Update

 

MP Firmware Update

We have an rp8420 which when connected to the MP we can go into CM and the DE then U and get the 'Air inlet temperature'.

We wanted to do the on our rp3440 and reading up on it discovered we needed to update the MP Firmware to Revision E.03.13. We actually updated to Revision E.03.15 which succeeded. However we still cannot access the menu option to show this 'Air inlet temperature'.

Can anyone shed any light on this please?
9 REPLIES 9
Torsten.
Acclaimed Contributor

Re: MP Firmware Update

Does it look like this?

MP:CM> de

Unrecognized Command : Type HE for help on the available commands

This MP doesn't support this command.

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   

Re: MP Firmware Update

Torsten,

Yes and I have pasted the exact output here for you.

[hathor-mp] MP:CM> de

Unrecognized Command : Type HE for help on the available commands

Any ideas?
Torsten.
Acclaimed Contributor

Re: MP Firmware Update

Take a look at the 2 boxes and you will agree - they are very different.



Still the same idea:

This MP doesn't support this command.



Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
Torsten.
Acclaimed Contributor

Re: MP Firmware Update

All you can get out of this MP is:

MP:CM> ps


PS
System Power state: On
Temperature : Normal

...

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   

Re: MP Firmware Update

Ah, that's a shame.

Reading the Operations Guide for the rp3440, on page 31 (Management Processor), it states the after updating the firmware to Revision E.03.13 certain features will be activated, one of which is the following:
-----------------------------------------
Display of information about various internal subsystems
â Field replaceable unit (FRU) information
â System power state, temperature information, and fan status
â Status of processors
-----------------------------------------
I thought this was going to mean we could get similar output as on our rp8420 system.