Management port configuration

[Hector Vargas]

Hello forum,

I have a rp3440 runing hpux 11.11 and I need to check the Management port (MP) configuration. basically it was working and the it stop. I will conect using the serial management port and probably reset MP however I would like to know if there are any logs that I should check to validate if the problem is a configuration/software issue or a hardware issue.

thanks,

[Steven E. Protter · Accepted solution]

Shalom,

If the management port itself, which is built into the server is flakey there is very little you can do other than call out hardware service to check it and replace it.

stm may be able to diagnos it and spot a problem:
http://docs.hp.com/en/diag/stm/str_1123pi.htm

Might be a similar situation
http://forums1.itrc.hp.com/service/forums/questionanswer.do?threadId=845553

http://archives.neohapsis.com/archives/hp/2005-q1/0018.html

SEP

[Hector Vargas]

thanks,

I think I will call HP.

[Hector Vargas]

I will call HP