HPE 9000 and HPE e3000 Servers
cancel
Showing results for 
Search instead for 
Did you mean: 

Management port configuration

 
SOLVED
Go to solution
Hector Vargas
Frequent Advisor

Management port configuration

Hello forum,

I have a rp3440 runing hpux 11.11 and I need to check the Management port (MP) configuration. basically it was working and the it stop. I will conect using the serial management port and probably reset MP however I would like to know if there are any logs that I should check to validate if the problem is a configuration/software issue or a hardware issue.

thanks,
3 REPLIES 3
Steven E. Protter
Exalted Contributor
Solution

Re: Management port configuration

Shalom,

If the management port itself, which is built into the server is flakey there is very little you can do other than call out hardware service to check it and replace it.

stm may be able to diagnos it and spot a problem:
http://docs.hp.com/en/diag/stm/str_1123pi.htm

Might be a similar situation
http://forums1.itrc.hp.com/service/forums/questionanswer.do?threadId=845553

http://archives.neohapsis.com/archives/hp/2005-q1/0018.html

SEP
Steven E Protter
Owner of ISN Corporation
http://isnamerica.com
http://hpuxconsulting.com
Sponsor: http://hpux.ws
Twitter: http://twitter.com/hpuxlinux
Founder http://newdatacloud.com
Hector Vargas
Frequent Advisor

Re: Management port configuration

thanks,

I think I will call HP.
Hector Vargas
Frequent Advisor

Re: Management port configuration

I will call HP