HPE 9000 and HPE e3000 Servers
1748259 Members
3515 Online
108760 Solutions
New Discussion

Re: Memory error

 
meekrob
Super Advisor

Memory error

hi , when i boot my L3000 , when it arrives at the memory test it gives this error:

ARLY BOOT VFP:SYSTEM ALERT
System Name:Uninitialized
Dat....

Alert LEVEL:10 = Boot Possible, Functionality lost

REASON FOR ALERT

SOURCE:7 = Memory
SOURCE DETAIL:1= Controller SOURCE ID:FF
PROBLEM DETAIL: 7=error fonction

LEDs: RUN Attention Fault Remote Powwer
Flash Flash off off on

LED state: Running non-os code. Non critical error detected

CHECK CHASSIS and console logs for error Messages 0x600000A771FF7034 24080000-type 12= Device status
0x580008A771FF034 000006807 03E1D19-type 11=timestamp 08/03/2004
A/a: ack read of this entry-Q/q: quit virtual front panel Display anything else redisplay the log entry

CHOICE:


N.B: I test my memories and they are ok , i can say that this a mother board problem?
1 REPLY 1
Shaikh Imran
Honored Contributor

Re: Memory error

Hi,
Are you able to boot the system after this ?

If yes then...

I will advise you to run stm & check for the possible problems.
Check if the memory is generating any single bit or double bit errors.
run STM verifiers if possible and you may come to know if any problem with the memory
or other device.

Regards,

I'll sleep when i am dead.