My L2000 unable to boot and keeps SYSTEM ELERT

[Shukor]

Hi There,

My L2000 suddently reboot and keeps receiving SYSTEM ELERT. OS cannot UP even I knowledged the error. TQ in adv. The error output like this:

************* SYSTEM ALERT **************
SYSTEM NAME: uninitialized
DATE: 05/07/2009 TIME: 05:42:59
ALERT LEVEL: 3 = System blocked waiting for operator input

REASON FOR ALERT
SOURCE: 1 = processor
SOURCE DETAIL: 1 = processor general SOURCE ID: 0
PROBLEM DETAIL: 0 = no problem detail

LEDs: RUN ATTENTION FAULT REMOTE POWER
FLASH FLASH FLASH ON ON
LED State: Unexpected Reboot. Running non-OS code. Non-critical error detected.
Check Chassis and Console Logs for error messages.

0xF8E010301100EFFF 00000000 0000EFFF - type 31 = legacy PA HEX chassis-code
0x58E018301100EFFF 00006D04 07052A3B - type 11 = Timestamp 05/07/2009 05:42:59
A: ack read of this entry - X: Disable all future alert messages
Anything else skip redisplay the log entry
->Choice:

[Torsten.]

Do as advised: "Check Chassis and Console Logs for error messages."

[Shukor]

Thanks torsten, but need your advice how to Check Chassis and Console Logs for error messages.

[Torsten.]

Go to the GSP and do

GSP> sl


SL

Select Chassis Code Buffer to be displayed:
Incoming, Activity, Error, Current boot or Last boot? (I/A/E/C/L) e
e

Set up filter options on this buffer? (Y/[N]) n


The first entry is the most recent Chassis Code
Type + CR and CR to go up (back in time),
Type - CR and CR to go down (forward in time),
Type Q/q CR to quit.

[Shukor]

I've got 3 log entries,

SOURCE: 1 = processor
SOURCE DETAIL: 1 = processor general SOURCE ID: 0
PROBLEM DETAIL: 0 = no problem detail

SOURCE: 1 = processor
SOURCE DETAIL: 1 = processor general SOURCE ID: 0
PROBLEM DETAIL: 0 = no problem detail

SOURCE: 8 = I/O
SOURCE DETAIL: 2 = system bus adapter SOURCE ID: 7
PROBLEM DETAIL: 3 = function failure


Torsten, what does its mean and what should I do now?

[Torsten.]

Not enough information to be sure, but

SOURCE DETAIL: 2 = system bus adapter SOURCE ID: 7
PROBLEM DETAIL: 3 = function failure

points to a problem either with the system board or the PCI board.

[Shukor]

Thanks!