HPE 9000 and HPE e3000 Servers
cancel
Showing results for 
Search instead for 
Did you mean: 

Navigation around console and GSP on rp7410 systems

 
Tran Vu
Occasional Visitor

Navigation around console and GSP on rp7410 systems

Hello,
We have two rp7410 HP-UX machines on site. The command of the GSP is quite different from the rp5450 model.

I got into the MP:CM> prompt and don't know how to get out.

Please let me know how can I navigate around this device and better yet, if you have any online document I will be very appreciated.

Thanks,
Vu
Long live Unix
4 REPLIES 4
Zygmunt Krawczyk
Honored Contributor

Re: Navigation around console and GSP on rp7410 systems

Hi,

from MP:CM> prompt enter ma command to go to the main menu.

Some information about MP navigation is included in

http://www.docs.hp.com/hpux/onlinedocs/A7025-96010-en/A7025-96010-en.pdf

see page 60->

Regards,
Zygmunt
Sridhar Bhaskarla
Honored Contributor

Re: Navigation around console and GSP on rp7410 systems

Hi Vu,

This is a cell based system and the MP navigation will be slight different from non-cell based systems.

Look at the following document on GSP

http://docs.hp.com/hpux/onlinedocs/B2355-90702/B2355-90702.html

Chapter " Superdome Console and Service Interface "

-Sri
You may be disappointed if you fail, but you are doomed if you don't try
Zygmunt Krawczyk
Honored Contributor

Re: Navigation around console and GSP on rp7410 systems

One more doc:

http://www.docs.hp.com/hpux/pdf/A6093-96022.pdf

see page 67->

Regards,
Zygmunt
Joshua Scott
Honored Contributor

Re: Navigation around console and GSP on rp7410 systems

Vu,

The

HE

command will show you a list of commands available in the command menu. Many are the same as the previous PA-RISC systems:

LC - lan console configuration
RS - Reset a Partition
CA - configure console serial port
ER - Enable remote access
DR - Disable remote access

What are you needing to do?

Josh
What are the chances...