HPE 9000 and HPE e3000 Servers
cancel
Showing results for 
Search instead for 
Did you mean: 

Networking rp5470=>SC10

 
ANNE_25
Occasional Advisor

Networking rp5470=>SC10

I need help setting up this connection. The SC10 contains 2- A5273A Bus Controller cards with only one currently being utilized. The rp5470 is not recognizing the SC10; which I have been trying to figure out if the A5273A on the SC10 needs to been addressed (it seems to make sense) but if it does what/how would I proceed to do so?, But if not why is there no recognition between the two?
"People Would Rather Be Ruined By Praise Than Saved By Criticism!"
1 REPLY 1
Torsten.
Acclaimed Contributor

Re: Networking rp5470=>SC10

The SC10 is a ultra2 SCSI device - no networking at all.

Make sure the dip switches on both controller cards have the same settings.

The switch 2 must be in status "1" (not in array mode).

Run ioscan to verify the connectivity.

Please consult the user guide for more information or ask again:

http://h20000.www2.hp.com/bc/docs/support/SupportManual/lpg28398/lpg28398.pdf?jumpid=reg_R1002_USEN

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!