HPE 9000 and HPE e3000 Servers
cancel
Showing results for 
Search instead for 
Did you mean: 

Old X-Terminal(700RX),Permission Denied when downloading file.

 
Gary_120
Occasional Visitor

Old X-Terminal(700RX),Permission Denied when downloading file.

On booting up,screen show:
...
Hardware type:C2708A
Hardware address:08000950cdcc
Board ID:3318C85521
...
Downloading /usr/lib/X11/700X/bin/C2708A
Can't open /usr/lib/X11/700X/bin/C2708A :Permission Denied
Boot Fail!
..
I have checked the file permissions and everthing seems OK. The Server HP-UX is 10.2 version.

I have make sure the network connection is OK,I can use that XT telnet to my server.
The Network has lots of XT,ALL OK,except this one. I don't know why.

and I have check this similar thread:http://forums.itrc.hp.com/cm/QuestionAnswer/1,,0x4a597e990647d4118fee0090279cd0f9,00.html , but no help to me.
5 REPLIES 5
Gary_120
Occasional Visitor

Re: Old X-Terminal(700RX),Permission Denied when downloading file.

Sorry, I don't now how to add "POINT" to this post.
Mark Grant
Honored Contributor

Re: Old X-Terminal(700RX),Permission Denied when downloading file.

I may be way off base here because it's been a while since I've been anywhere near an X terminal but I believe they often used to use tftp to download the file.

If this is the case, you will need to set up tftp. I belive some could also use NFS and other protocols too.

I guess hwat I'm getting at is that maybe you need to look at some configuration issue with protocol being used to get the file rather than looking at the file itself
Never preceed any demonstration with anything more predictive than "watch this"
Stuart Powell
Super Advisor

Re: Old X-Terminal(700RX),Permission Denied when downloading file.

Do you have other Xterminals working that use the C2708A configuration file?

Had this Xterminal worked before?

What version of Enware is installed?

Did you check the permissions down the entire directory tree?

Sorry about the number of questions.

Stuart
Sometimes the best answer is another question
Gary_120
Occasional Visitor

Re: Old X-Terminal(700RX),Permission Denied when downloading file.

Unluckily,Only one C2708A Xterminal in network,and this XT was working fine before.

Enware version is B.07.11,

I have checked the file and directory permissions,it's ok.
Stuart Powell
Super Advisor

Re: Old X-Terminal(700RX),Permission Denied when downloading file.

A good troubleshooting tool that I have used in the past on Xterminals is to manually enter all of the configuration at the Xterminal. That eleminates the Xterminal as the root cause of the problem.
Another troubleshooting tool is the "telnet" session. Can you telnet to the file server, and XDMCP server?
Check with the networking people to make sure there have been no new equipment installed between the xterminal and the boot server (although this would not give a permissions error).
We also experiences some very unusualy behaviour when there was a network hardware component that was only working intermittently.

Stuart
Sometimes the best answer is another question