PCI scsi board question

[manuel j hurtado m]

HI,
can i install a A4800A PCI Ultra SCSI board in a server rp3410 with HP-UX 11i

[Steven E. Protter]

You need to check the possible scsi boards for the rp3410 server at http://partsurfer.hp.com

Click server then pick your server and check interface cards.

If the partnumber is listed, yes. If not,no.

SEP

[Sridhar Bhaskarla]

Hi Manuel,

I believe you can and I dont' see any problem. RP3410 is very limited on PCI slots. As long as you can manage them well, I don't see an issue.

-Sri

[Andrew Rutter]

Hi,

should'nt be too much of a problem. Hpux 11i should pick it up aswell so need to install drivers for it, but been limited in slots depending upon future expansion you might be better off buying the dual fwd interface card instead.

Andy

[Sanjay_6]

Hi,

Doesn't look like the controller is supplied / supported on rp 3410,

http://partsurfer.hp.com/cgi-bin/spi/main?sel_flg=partinfo&template=main&cpric=&psrchmode=&partsrch=A4800A&submit.x=10&submit.y=7

Hope this helps.

Regds

[Sยภเl Kย๓คг · Accepted solution]

Hi Manuel
As far as rp3410 is concerned PCI shouldn't be any problem.However it is advised to lock a call with the HP Call centre and get the support from the if it is under contract of HP,how ever 11i shouldn't be any problem.
regards
SK

[marie-noelle jeanson_1]

According to the HP information I have, this is not supported. For SCSI cards supported on rp34xx, see: http://www.hp.com/products1/servers/rackoptimized/rp3400_series/supplies.html

Marie-Noelle

[manuel j hurtado m]

Thank you for your help i will test the board in tha server to see if work.