1748182 Members
3613 Online
108759 Solutions
New Discussion юеВ

Re: PDHC leds

 
DdeBlance_2
Advisor

PDHC leds

I have a cell board installed in an rp7420. Firmware has been up dated to 4.1. Now one of the leds on the middle of the boards (DS1) is blinking. Is that normal??
5 REPLIES 5
cnb
Honored Contributor

Re: PDHC leds

Hi,

The 4 LEDs indicate POST status.

Yes.

Rgds,

DdeBlance_2
Advisor

Re: PDHC leds

Ok, when I look in
MP:CM>ps >c
I see

PDHC status Leds : ***-

Is this ok?
Benoy Daniel
Trusted Contributor

Re: PDHC leds

Go to MP prompt, type PS. You should able to see all installed cells in the server
DdeBlance_2
Advisor

Re: PDHC leds

Yea, I see the cell board I have installed. I'm just trying to figure out if that last led not showing "*" is a problem.

Thanks
-D
DdeBlance_2
Advisor

Re: PDHC leds

Ok I'm still seeing cell boards with this.

You may display detailed power and hardware status for the following items:

T - Cabinet
S - System Backplane
G - MP (Core I/O)
P - IO Chassis
C - Cell
Select Device: c
Enter cell number: 1

HW status for Cell 1 : NO FAILURE DETECTED

Power status : on, no fault
Boot is not blocked
PDH memory is shared
Processor Compatibility : OK
RIO cable status : connected
RIO cable connection physical location : PCI Domain 1
Core cell is cell 1
Attention Led is off

PDHC status Leds : ***-

CPU Module Slot 0 1 2 3
Populated P P
Local 48V Good * *
Power Enabled * *
Power Good * *

(* - True, P - Processor, T - Terminator)



DIMMs populated:
0 . . . 4 . . . 8 . . .12 . . .
* * * *

1 1 1 1 1 1
VRM's 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5
Present : * * * * * * * * * * * * * * *
Enabled : * * * * * * * * * * * * * * *
Pwr Good : * * * * * * * * * * * * * * *


Front Side Bus Freq. : 200 MHz
CPU Core Freq. : 1000 MHz
CPU Part Number : PA8800

System Boot Rom (SFW) firmware rev 24.004
PDH controller (PDHC) firmware rev 3.031, built THU NOV 09 21:37:37 2006
MICE revision is 1.0

[mp] MP:CM>




What does the led status mean? This system boots and is working, but I can't ship unless I know the details? On the cell board the led is flashin...