PROBLEM IN HP9000 RP4440

[majid_3]

THe LED SYSTEM IN MY RP4440 is red:

WHAT IS THE PROBLEM AND CAN YOU GIVE ME A SOLUTION

MANY THANKS

[Luk Vandenbussche]

Check the troubleshooting section in

http://docs.hp.com/en/A9550-96001/A9950-96001_rp4410_rp4440_Maint.pdf

[Joelmel Roche]

Hi,
Follow this example steps and post the logs

from the console---
(Type Cntl+b)
Leaving Console Mode - you may lose write access.
When Console Mode returns, type ^Ecf to get console write access.

GSP Host Name: test
GSP> sl
SL

Select Chassis Code Buffer to be displayed:
Incoming, Activity, Error, Current boot or Last boot? (I/A/E/C/L) e

Set up filter options on this buffer? (Y/[N]) n

The first entry is the most recent Chassis Code
Type + CR and CR to go up (back in time),
Type - CR and CR to go down (forward in time),
Type Q/q CR to quit.

Log Entry # 0 :
SYSTEM NAME: TEST
DATE: 06/19/2002 TIME: 04:18:24
ALERT LEVEL: 2 = Non-Urgent operator attention required

SOURCE: 0 = unknown, no source stated
SOURCE DETAIL: 0 = unknown, no source stated SOURCE ID: FF
PROBLEM DETAIL: 0 = no problem detail

Type + CR and CR to go up (back in time),
Type - CR and CR to go down (forward in time),
Type Q/q CR to quit. q

GSP> ps

GSP> co ---back to console

[tony78]

connect to the console and go to the MP prompt using CTRL+B
Then use the SL (show log) command to see what append.
Do CO command to come back to console mode

[tkc]

when the system led is red, it means 'Hard fault, system halted'. Check the led status on the diagnostic panel. The diagnostic panel is located under the top cover and is attached to the top of the power supply
cage.

[tkc]

try assigning points to those who replied you. you will get faster response this way.