HPE 9000 and HPE e3000 Servers
cancel
Showing results for 
Search instead for 
Did you mean: 

Port pbroblem on HP 9000 rp3440 Server

 
SOLVED
Go to solution
kacou
Regular Advisor

Port pbroblem on HP 9000 rp3440 Server

In this system below i havn't video bord (card). But i need to install the OS (hpux). Someone know how can i connect my monitor? or what is the procedure to make the installation?

-------------------------------
# model
9000/800/rp3440
# uname -r
B.11.23
#
HP 9000 rp3440 Server
10 REPLIES 10
Pedro Cirne
Esteemed Contributor
Solution

Re: Port pbroblem on HP 9000 rp3440 Server

Hi,

Connect it to a laptop through the serial port and use a terminal emulator.

You may also use a LAN console..

Pedro
Torsten.
Acclaimed Contributor

Re: Port pbroblem on HP 9000 rp3440 Server

If you can run commands on hp-ux you already have an OE installed, right?

You need to use a terminal (PC+putty) to the serial MP connector or make a telnet connection to the MP.

The VGA port you can see is not supported on this system.

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
Highlighted
kacou
Regular Advisor

Re: Port pbroblem on HP 9000 rp3440 Server

I want to make a new installation(using the lan). this server havn't an ip adress. so what is the procedure?
SUDHAKAR_18
Trusted Contributor

Re: Port pbroblem on HP 9000 rp3440 Server

Connect through console, or configure MP lan using laptop & use MP Ip address to connect.
kacou
Regular Advisor

Re: Port pbroblem on HP 9000 rp3440 Server

idon't know the MP lan using laptop ? what is the process? show me the way to do it please.
Torsten.
Acclaimed Contributor

Re: Port pbroblem on HP 9000 rp3440 Server

You need to connect to the MP to get console access (via LAN or serial cable).

Switch to console
MP> co

boot until you read the boot menu, stop booting and do a

Boot of your system using the Ignite-UX server. If your Ignite serverâ s IP address is ww.xx.yy.zz:

BCH> bo lan.ww.xx.yy.zz install
Interact with IPL: n

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
kacou
Regular Advisor

Re: Port pbroblem on HP 9000 rp3440 Server

In the same way, i want to do a mirror of disk in the same system.
what is the procedure?
SKR_1
Trusted Contributor

Re: Port pbroblem on HP 9000 rp3440 Server

Refer the attached doc for mirroring of disk.

Thanks

SKR
kacou
Regular Advisor

Re: Port pbroblem on HP 9000 rp3440 Server

i read it a call you after!!

thanks a lot