HPE 9000 and HPE e3000 Servers
cancel
Showing results for 
Search instead for 
Did you mean: 

Power Supply problem in rp3440

 
Power supply in rp3440
Occasional Advisor

Power Supply problem in rp3440

In iLO display , power suply failure shows PS0 but physically server have PS1 & PS2. So how to identify which pwer supply gone bad?
5 REPLIES 5
Sameer_Nirmal
Honored Contributor

Re: Power Supply problem in rp3440

Hi,

Check physically the power supply modules status LEDs. The two LEDs on the working module should be Green. The one which doesn't have both LEDs green should be non-working p/s module.

As far the status of p/s modules shown in the iLO interface is concerned, it might be referring PS0 as PS1.

Refer this link as well.
http://docs.hp.com/en/A7137-96001-en/A7137-96001-en.pdf
Power supply in rp3440
Occasional Advisor

Re: Power Supply problem in rp3440

Hi Sameer,
I could not see any LED related to power supply. I have checked in hardware manual also which is attched in your link.

Thanx for reply.

Regards

Sandip H.
Sameer_Nirmal
Honored Contributor

Re: Power Supply problem in rp3440

Sandip,

As mentioned in the manual, you need to open the front bazel to see those LEDs.
Power supply in rp3440
Occasional Advisor

Re: Power Supply problem in rp3440

Hi Sameer,
Thanx for your support

Regards

Sandip H.
Power supply in rp3440
Occasional Advisor

Re: Power Supply problem in rp3440

I have found a solution to this question