HPE 9000 and HPE e3000 Servers
cancel
Showing results for 
Search instead for 
Did you mean: 

Problem with GSP configuration on L3000.

 
SOLVED
Go to solution
Gino Castoldi_2
Honored Contributor

Problem with GSP configuration on L3000.

Hi,

HP-UX 11.11 L3000 GSP rev B. (built-in SWC).
The GSP Lan port has a ip address, hostname,
and I added the arp entry. I am trying to set this up remotely, the server is in a different
location.

I setup the basic networking part of the SWC (GSP rev B.).
I have the SWC browser up and running and I have access to the GSP.
However, when I hit a ctrl^b it brings up these messages and it won't allow me
to enter any commands (GSP or otherwise).

I first logged in:
Service Processor login: [return]
Service Processor password: [return]
After I login these messages are displayed:
***********************************************
GSP ACCESS IS NOT SECURE
No GSP users are currently configured and remote acess is enabled.
Set up a user with a password (see SO command)
OR
Disable all types of remote access (EL or ER commands)
***********************************************

Then I typed in a control^b and I keep getting the same message with no write access to the console.

[Read only - use ^Ecf for console write access.]

Any ideas as to what is wrong here?

10 points to any good answer.
TIA, Gino
6 REPLIES 6
Shahul
Esteemed Contributor
Solution

Re: Problem with GSP configuration on L3000.

Hi,

You need to type as directed to get write acces. ie, ^Ecf, then you have write access to console.

Good luck
Shahul
Robert-Jan Goossens
Honored Contributor

Re: Problem with GSP configuration on L3000.

Gino,

Check this doc,

http://www5.itrc.hp.com/service/cki/docDisplay.do?docLocale=en_US&docId=200000065680194

ttytype gets the terminal type wrong on the console DocId: WCMDKBRC00004843

Robert-Jan
G. Vrijhoeven
Honored Contributor

Re: Problem with GSP configuration on L3000.

Gino,

To need type e c f and you will get write access. The console is locked by an other session. If tyou want to prevent this in the future log out.

Gideon
Elmar P. Kolkman
Honored Contributor

Re: Problem with GSP configuration on L3000.

Right now you are in read only mode: you can see what's printed to the console, but can not do anything yet. You can not login or do the B you try.

To switch from read-only to read-write you have to do what it says: E cf

Then you can login or use B
Every problem has at least one solution. Only some solutions are harder to find.
Fabio Ettore
Honored Contributor

Re: Problem with GSP configuration on L3000.

Ciao Gino,

from ITRC knowledge base I found a doc

KBRC00003019 - L-Class - How to get GSP console control

[Read only - use ^Ecf for console write access.] means that it is possible just for a person to take the control of GSP.
In order to do it just issue CTRL+Ecf (You need to do "CTRL+C", then press "E&F" together).

I hope this helps you.

Best regards,
Ettore
WISH? IMPROVEMENT!
Gino Castoldi_2
Honored Contributor

Re: Problem with GSP configuration on L3000.

Hi,

The SWC is working now.

Thank you for your help.
Gino