HPE 9000 and HPE e3000 Servers
cancel
Showing results for 
Search instead for 
Did you mean: 

Process for addind Memorries in slots of server RP5430

 
ASPA_1
Occasional Visitor

Process for addind Memorries in slots of server RP5430

Good afternoon,

I have buy 4 memories cards of 512 KB in order to increase the memory into one server RP5430 (geniune 2 X 512 KB).
What is the exact process for doing this operation ? Can I put the cards in the slots also ? Is there another action to do after that ?

Bye.
3 REPLIES 3
DCE
Honored Contributor

Re: Process for addind Memorries in slots of server RP5430



Power down the system

add the memory

power up the system

increase swap
Torsten.
Acclaimed Contributor

Re: Process for addind Memorries in slots of server RP5430

Please unplug the power cords after shutdown. After installation, go to the boot menu and check

> IN ME
(information memory)

In case of trouble re-seat the modules.

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
freddy_21
Respected Contributor

Re: Process for addind Memorries in slots of server RP5430

1. shutdown your server
2. unplug all power cable
3. All your memory have a same size.
I think your current memory at slot 0a, 0b.
Put your memory at slot 1a,1b 2a,2b. you can see at your memory slot.
4. startup your server
5. interupt at BCH menu
Main menu> in
information menu> me
check about memory configuration, total of memory.
sometime your memory not seat properly. you need unplug and plug with properly.
6. startup server
7. increse swap. normally 2 - 3 time for total memory depend your application

thanks
freddy