HPE 9000 and HPE e3000 Servers
cancel
Showing results for 
Search instead for 
Did you mean: 

RP 4440 POWER STATUS IS FAULT

 

RP 4440 POWER STATUS IS FAULT

I have a serever rp 4440 with hp-ux 11.23, by monitoring the server status from the MP, it indivates that the power status is fault although the server is up and running.

can you help me to find a solution to this issue.
4 REPLIES 4
Murat SULUHAN
Honored Contributor

Re: RP 4440 POWER STATUS IS FAULT

Hi

Connect to MP

then type CM
then type PS

capture all output and submit here

You can also check Power Supply LEDs

Best Regards
Murat
Murat Suluhan
Steven E. Protter
Exalted Contributor

Re: RP 4440 POWER STATUS IS FAULT

Shalom,

I'd use the SL (show logs) option in the GSP/MP (now iLo) card.

This will let you read the faults and clear the VSP on the system.

SEP
Steven E Protter
Owner of ISN Corporation
http://isnamerica.com
http://hpuxconsulting.com
Sponsor: http://hpux.ws
Twitter: http://twitter.com/hpuxlinux
Founder http://newdatacloud.com
Ron Irving
Trusted Contributor

Re: RP 4440 POWER STATUS IS FAULT

I believe the rp4440 has dual pwr supplies. It may be the case that only 1 of them is faulty, and would need to be replaced. As was recommended, please post the output of the cm:ps command.

hope this helps
Should have been an astronaut.
YAQUB_1
Respected Contributor

Re: RP 4440 POWER STATUS IS FAULT

Hi Shakeel,

Put the MP/GSP system event log:

MP> cm
MP:CM> sl ------> press "D"
MP:CM> ps

BR/
Yaqub