RP4440 lost RTC and cannot see second Hard Disk from BCH

Matthew Murdock · ‎01-31-2019

Not sure where the issue is. Initially I had a 11.31 os loaded at intscsib.0. Then reloaded the second disk (instscsia.1) with 11.11 and It ran for about a few months no issues, then in about month 5 or 6 the system died on the developer and upon reboot, it took 5 hours.

Come to find out the RTC and the MP batteries died.

Finally got the system up to the BCH, set the time, set the autoboot, autosearch and quick boot, and the original 11.31 disk boots. IT cannot see the second disk or path from ioscan (ioscan -funC disk). IOSCAN does see the dvd drive.

At the BCH Service --> SCSI shows both paths set to scsi ID 7. Is this correct? I have tried to set one Path ID to be 15 and 6 but still does not see the second disk with SEA.

Torsten. · ‎01-31-2019

Please show the output.
It cannot be ID 7 for the disk, this is reserved.
AFAIR the internal disk IDs are fixed anyway.

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!

S_Logan · ‎02-17-2019

Hi Mathew,

Could you please share the error messages and related ioscan output, the issue probably due to loss of boot info as both the batteries dried.

I work for HPE

[Any personal opinions expressed are mine, and not official statements on behalf of Hewlett Packard Enterprise]

RP4440 lost RTC and cannot see second Hard Disk from BCH

RP4440 lost RTC and cannot see second Hard Disk from BCH

Re: RP4440 lost RTC and cannot see second Hard Disk from BCH

Re: RP4440 lost RTC and cannot see second Hard Disk from BCH

Hewlett Packard Enterprise International