Re: install 2nd CPU on rp5450

[Vincent_5]

Hi Guys,
Have anyone of you face this problem before. I have a rp5450 running on hpux 11.11 install with 1 x CPU . Now I wanted to add a second CPU, it failed. After inserting the second CPU there is no display on the screen. But, when I move the second CPU to the lst slot it work. This show that the CPU is working, but why it does not work when I instert to the 2nd slot. Pls advice???


Regards
Vincent

[Torsten.]

The CPU load order is slot number 0,3,1,2.
You must use the same CPU model.
Please compare the part numbers.

[Robert-Jan Goossens]

Hi Vincent,

CPUs must be installed in the following slot number order: For

rp5400 slots 0, 3
rp5430 slots 0, 2
rp5450 slots 0, 3, 1, 2
rp5470 slots 0, 2, 1, 3

For rp5400 and rp5450 single CPU configurations, a processor terminator must be installed in slot 3.

MOre info:
http://www.docs.hp.com/en/A5191-96022/ch01s02.html

Best regards,
Robert-Jan

[RAC_1]

After putting it into send slot, run cstm and check if it reports any error or not. After putting it in 2nd slot, does server boot?

[Vincent_5]

Hi Guys,
Thanks for the info, but I installed the 2nd CPU on slot 3 where the terminator is. I remove the terminator and install the 2nd CPU, after which I try to bring up the server, on the console, I cannot see any display , there is no indication of hardware error but my run light keep blinking. I waited for 25mins or more till I gave up and remove the 2nd CPU from the server. Pls advice???


Regards
Vincent