HPE 9000 and HPE e3000 Servers
cancel
Showing results for 
Search instead for 
Did you mean: 

Re: install 2nd CPU on rp5450

 
Vincent_5
Super Advisor

Re: install 2nd CPU on rp5450

Hi Guys,
Have anyone of you face this problem before. I have a rp5450 running on hpux 11.11 install with 1 x CPU . Now I wanted to add a second CPU, it failed. After inserting the second CPU there is no display on the screen. But, when I move the second CPU to the lst slot it work. This show that the CPU is working, but why it does not work when I instert to the 2nd slot. Pls advice???


Regards
Vincent
nothing is better than to know more
4 REPLIES 4
Torsten.
Acclaimed Contributor

Re: Re: install 2nd CPU on rp5450

The CPU load order is slot number 0,3,1,2.
You must use the same CPU model.
Please compare the part numbers.

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
Robert-Jan Goossens
Honored Contributor

Re: Re: install 2nd CPU on rp5450

Hi Vincent,

CPUs must be installed in the following slot number order: For

rp5400 slots 0, 3
rp5430 slots 0, 2
rp5450 slots 0, 3, 1, 2
rp5470 slots 0, 2, 1, 3

For rp5400 and rp5450 single CPU configurations, a processor terminator must be installed in slot 3.

MOre info:
http://www.docs.hp.com/en/A5191-96022/ch01s02.html

Best regards,
Robert-Jan
RAC_1
Honored Contributor

Re: Re: install 2nd CPU on rp5450

After putting it into send slot, run cstm and check if it reports any error or not. After putting it in 2nd slot, does server boot?
There is no substitute to HARDWORK
Vincent_5
Super Advisor

Re: Re: install 2nd CPU on rp5450

Hi Guys,
Thanks for the info, but I installed the 2nd CPU on slot 3 where the terminator is. I remove the terminator and install the 2nd CPU, after which I try to bring up the server, on the console, I cannot see any display , there is no indication of hardware error but my run light keep blinking. I waited for 25mins or more till I gave up and remove the 2nd CPU from the server. Pls advice???


Regards
Vincent

nothing is better than to know more