HPE 9000 and HPE e3000 Servers
cancel
Showing results for 
Search instead for 
Did you mean: 

Server not running after reboot

 
YMJ
Frequent Advisor

Server not running after reboot

Hi all

we have 2 rp7420 servers in cluster. we did some modification to the volume group and and installed online JFS that required reboot. one node is up and running and the other is not.

I login to the MP and found the partition and cell is off. I coundn't bring it up with MP>PE command

here some of the output:

MP:CM> bo

This command boots the selected partition.


Part# Name
----- ----
0) Partition 0

Select a partition number: 0

Do you want to boot partition number 0? (Y/[N]) y

-> The selected partition will be booted.

Sorry, command failed: RtnCodeNoPoweredCellSlotsInPartition

then MP>PS

HW status for Cell 1 : FAILURE DETECTED

Power status : NOT VIABLE, no fault
Boot is blocked
PDH memory is not shared
Processor Compatibility : FAULT
RIO cable status : UNDEFINED
RIO cable connection physical location : cannot be determined
Core cell is INVALID
Attention Led is off

PDHC status Leds : ----

CPU Module Slot 0 1 2 3
Populated
Local 48V Good
Power Enabled
Power Good

(* - True, P - Processor, T - Terminator)



DIMMs populated:
0 . . . 4 . . . 8 . . .12 . . .


1 1 1 1 1 1
VRM's 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5
Present :
Enabled :
Pwr Good :


Front Side Bus Freq. : 250 MHz
CPU Core Freq. : 0 MHz
CPU Type :

System Boot Rom (SFW) firmware rev 0.000
PDH controller (PDHC) firmware rev 0.000, built THU JAN 01 00:00:00 1970
MICE revision is 0.0

please, help?
4 REPLIES 4
Patrick Wallek
Honored Contributor

Re: Server not running after reboot

It appears that you have a serious power problem. Check that all power cords are plugged in. Check that all power supplies are active and that none are bad. If you have a UPS attached to this machine verify that it is functioning.

Sameer_Nirmal
Honored Contributor

Re: Server not running after reboot

What you see in
MP -> CM -> DE

YMJ
Frequent Advisor

Re: Server not running after reboot

Thanks all

we solve the power issue by unpluging the power cables and then plug them again. the server started after that normally
YMJ
Frequent Advisor

Re: Server not running after reboot

closed