HPE Community
HPE 9000 and HPE e3000 Servers
1753269 Members
4998 Online
108792 Solutions
New Discussion юеВ

Re: Sorry, the maximum number of active Web sessions has been reached.

 
harmt01
Frequent Advisor

тАО06-18-2008 07:45 AM

тАО06-18-2008 07:45 AM

Sorry, the maximum number of active Web sessions has been reached.

I have an RP-4440 with HP-UX 11.11 running.
I get this message on the ILO about one a week and it will only go away after a reboot. Someone said there is a rest button, WHERE?
Is there a fix for this issue?
Life isn't about how you survived the storm, it's about how you danced in the rain!
0 Kudos
2 REPLIES 2
Torsten.
Acclaimed Contributor

тАО06-18-2008 11:14 AM

тАО06-18-2008 11:14 AM

Re: Sorry, the maximum number of active Web sessions has been reached.

Check your firmware version first:

MP:CM> sysrev

MP FW : E.03.32
BMC FW : 04.06
System FW : 46.34


You can either disconnect all users (di) or reset the MP (xd->r) meanwhile via a telnet/ssh/serial connection.

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
0 Kudos
Matti_Kurkela
Honored Contributor

тАО06-18-2008 11:00 PM

тАО06-18-2008 11:00 PM

Re: Sorry, the maximum number of active Web sessions has been reached.

See Figures 1-12 and 1-21 in the User Service Guide for rp4440:

http://docs.hp.com/en/A9950-96011/ch01s04.html#i1021547

On the rear panel of the server, left of the "local" serial port, there are some air holes. According to the Figure 1-21, the iLO reset button should be accessible through one of those holes.

MK
MK
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.