System power off during firmware updation

[shabash]

last day i was updating the MP firmware of rp3440 system and while updating the power is interrupted and system goes off.
when i power on the server machine it starts but mp not accessible,lan ip was not previously set but os was installed on the system.

Now VGA port is by default on disable state how can access the mp?wht are the possible ways to troubleshoot the problem.

[Torsten.]

Hi,

check the status of the MP LEDs:

http://docs.hp.com/en/A7137-96008/ch01s03.html#d0e2258

Figure 1-16 iLO MP Card LAN LEDs

Table 1-15 iLO MP Card LAN LEDs

http://docs.hp.com/en/A7137-96008/ch01s03.html#i1021563

If the self test never ends or no LED is on you have killed the MP.

[shabash]

The MP port LED is green,whenever connect to NOTEBOOK with crosscable or in switch MP LAN port is Green.

But i am unable to access nothing displayed.
How i troubleshoot more regarding this problem.

[Torsten.]

Did you try to connect your PC via a null modem cable (serial)?

[Tim Nelson]

As Torsten stated a null-modem cable will be needed to gain access if you can.

Power failure during a EEPROM burn typically will render things un-usable and require a call to HP in order to replace the MP.

but, if you have free time, see if you can connect and see if there is enough brains left to reflash.

http://docs.hp.com/en/5991-6006/5991-6006.pdf

[Asim_5]

The LED status is green,it also connects with arp -s but wont ping or display with null modem cable.
Now regarding the document everything i tried nothing displayed.
One mp reset is remaining and how it works kindly some one help................

[Torsten.]

Ping with null modem cable? unlikely ...

Just to verify - did you check the MP port or the core LAN port?

See

http://docs.hp.com/en/A7137-96008/ch01s03.html#i1021437

[shabash]

Now i see the LED status for MP lAN

There are four LEDs
1.self test(OFF)
2.10BT (ON Green)
3.100BT (OFF)
4.standby power (OFF)

Now if its dead then tell me which specific part i have to request or wht else i can do for this?should i replace the whole board or Just mp lan card,

Anyone recommend which part number?

[Torsten.]

The MP is a single card - it is not integrated into the system board.

Anyway, green lights are good ;-)

Check again, if you can get serial access, see

http://docs.hp.com/en/A7137-96008/ch03s06.html#babdbdag

[shabash]

Light is green but how can i see the MP display i cannot see anything the connection through serial not connecting i have tried with 3 diffrent Notebooks :-()

Now what can i doooo.............