HPE 9000 and HPE e3000 Servers
1752696 Members
6056 Online
108789 Solutions
New Discussion юеВ

Re: System power off during firmware updation

 
Torsten.
Acclaimed Contributor

Re: System power off during firmware updation

Try this (taken from a similar system rp3440):

#stty +queryGSP < /dev/GSPdiag1
GSP is functional.


Did you already try to reset the MP again?

(by pressing the reset button on the MP / by removing the power cords)

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
shabash
Frequent Advisor

Re: System power off during firmware updation

Before i had reset the mp but it wont displayed any thing.Now the command you have mentioned where do i try that one?
Torsten.
Acclaimed Contributor

Re: System power off during firmware updation

Sorry, this command has to run on hp-ux.
Is the system running (it would even without the MP - console should be on the serial port 1, if not on MP).

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
shabash
Frequent Advisor

Re: System power off during firmware updation

The os is installed and not sure that its running or not coz lan ip is not accessible.
Now what other step should i take to get atleast display for the system