HPE 9000 and HPE e3000 Servers
1748182 Members
3516 Online
108759 Solutions
New Discussion юеВ

Re: Unable to telnet into MP

 
quixalogical
Advisor

Unable to telnet into MP

I have run arp -s and associated an IP to the MAC, firewall is wide open, cable checks out, and I can telnet to other machines from the same workstation (with the same cable). I get...

Could not open connection to the host, on port 23: Connect failed.

As well I have flushed the cache and reconfigured the connector multiple times. Any suggestions? Thanks again.
5 REPLIES 5
Torsten.
Acclaimed Contributor

Re: Unable to telnet into MP

You should connect to the serial port and check/adjust the network settings. Maybe telnet is disabled.

MP:CM> ls
MP:CM> lc

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
quixalogical
Advisor

Re: Unable to telnet into MP

I gather that the MP was set up for DHCP so I connected it to a live network and it grabbed an IP. After that I was able to get in and change the IP to what I needed. Now however port 23 is not allowing access on the management port or via web browser. Is there any other way I can access to the management port via a windows laptop? Thanks again.
Torsten.
Acclaimed Contributor

Re: Unable to telnet into MP

What server model?

Some have ssh access enabled by default, for other models this is a licensed feature.

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
quixalogical
Advisor

Re: Unable to telnet into MP

The server in question is a HP9000 rp 3440. I was able to get in on the IP it picked up on DHCP I just had to change one of the connection settings on my laptop. Thanks again. As usual I found what I was looking for here. Thanks again.

James
Torsten.
Acclaimed Contributor

Re: Unable to telnet into MP

Please read this:

http://forums11.itrc.hp.com/service/forums/helptips.do?#33

Have fun!

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!