cancel
Showing results for 
Search instead for 
Did you mean: 

a6826a

 
SOLVED
Go to solution
Jon Steele
Valued Contributor

a6826a

can some please explain what these error codes mean and what could have caused them.

0/3/1/0: Fibre Channel Driver Read bad NVRAM Header.
Additional Status is 0x01
Status == 0x01: Bad/Incorrect Signature.
Status == 0x02: Incorrect Minimum Version.
Status == 0x03: Incorrect Checksum.
init of hardware not successful. id=10772312 and my_isc=30
0/3/1/1: Fibre Channel Driver Read bad NVRAM Header.
Additional Status is 0x01
Status == 0x01: Bad/Incorrect Signature.
Status == 0x02: Incorrect Minimum Version.
Status == 0x03: Incorrect Checksum.
init of hardware not successful. id=10772312 and my_isc=31
0/4/1/0: Fibre Channel Driver Read bad NVRAM Header.
Additional Status is 0x01
Status == 0x01: Bad/Incorrect Signature.
Status == 0x02: Incorrect Minimum Version.
Status == 0x03: Incorrect Checksum.
thank you
Jon
3 REPLIES 3
Torsten.
Acclaimed Contributor
Solution

Re: a6826a

Hi Jon,

never seen such messages.
Are you using an unsupported FC card in a hp-ux server by chance?

I'm asking this, because of the fact that the driver is "pushing" the firmware to the card and this looks like something going wrong at this stage.

If the used card is that one from the subject, it could be a bad card too.

But a firmware not current or something else could be the reason. Some more information is needed.

"Incorrect Minimum Version" looks like firmware - would you agree?

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
Torsten.
Acclaimed Contributor

Re: a6826a

If the card is installed in a PA-RISC server, this thread may help you:

http://forums.itrc.hp.com/service/forums/questionanswer.do?threadId=1137500

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
Jon Steele
Valued Contributor

Re: a6826a

Thanks for your help.These cards are off site and I am trying to find out what machine they are putting them in.They worked fine in a compaq machine.So I do think it is a firmware issue,or it is the machine they are putting them into.I am getting the cards back so I will check them when they come back.
Thank you
Jon