HPE 9000 and HPE e3000 Servers
Showing results for 
Search instead for 
Did you mean: 

chars L2000 & L3000

Go to solution
Carme Torca
Super Advisor

chars L2000 & L3000


I would like to put this targets in the servers:
L2000: 1 GB Ethernet and 1 DAT (inside or outside)
L3000: 1 DAT (inside or outside), (better I could put it inside the server)

Is it possible?, How could I known all them?

Thanks a lot of!
Users are not too bad ;-)
Robert-Jan Goossens
Honored Contributor

Re: chars L2000 & L3000

Hi Carmen,

For the L2000

A4926A LAN adapter - 1000Base-SX PCI Gigabit Ethernet LAN adapter - Supports all PCI bus configurations

A4929A LAN adapter - 1000Base-T PCI Gigabit Ethernet LAN adapter - Supports all PCI bus configurations

A5558A DDS-3 (DAT) Tape Drive - 12GB (24GB with Data Compression) - 5.25-inch, Single Ended SCSI-2 Interface

The can also be used in the L3000


T G Manikandan
Honored Contributor

Re: chars L2000 & L3000

The L-class servers on the rear side have 12 PCI slots with which the first slot is the Core I/O slot which can be used to connect a DAT drive.
if you are using the Rack type then there is a Rack mounted adapter behind where the DAT drive can be fixed internally.

With these PCI slots you can connect the gigabit adapter.

check the link for the compatible gigabit adapters for rp5400


Also check the PCI installation chapter of this document.THis has all the required